#SENTRY SAFE LOST COMBINATION S0207 CODE#
country code designator, the Secured Access Method MUST be used to program new or additional valid keys to the SKREEM/WCM. If two valid Sentry Keys are not available, or if the vehicle does not have a U.S. This programming method also requires access to at least two valid Sentry Keys. The Customer Learn feature is only available on domestic vehicles, or those vehicles which have a U.S. If confused, ask any ASE shop in USA for help NOTE: Once a Sentry Key has been programmed asĪ valid key to a vehicle, it cannot be programmedĪs a valid key for use on any other vehicle. Words, the engine will stall after about two seconds
While in the Customer Learn mode (SKIS indicatorįlashing), the SKIS will respond as though the vehicle NOTE: If an attempt is made to start the vehicle To the Off position for more than about fifty seconds. Valid Sentry Keys, or if the ignition switch is turned See a blank, if it has already programmed eight (8)
Non-blank Sentry Key transponder when it should The Customer Learn programming mode if it sees a Programming mode and the programming will be Not completed in the given sequence, or within theĪllotted time, the SKIS will exit the Customer Learn
In their entirety for each additional Sentry Started using the newly programmed valid SentryĮach of these steps must be repeated and completed Programming mode and the vehicle may now be The SKIS will immediately exit the Customer Learn Three seconds, then turn off to indicate that theīlank Sentry Key has been successfully programmed. SKIS indicator will stop flashing, stay on solid for (6) About ten seconds after the completion of Stepĥ, a single audible chime tone will sound and the The Off position, replace the valid Sentry Key with aīlank Sentry Key transponder, and turn the ignition Learn programming mode, turn the ignition switch to (5) Within sixty seconds of entering the Customer Sound to indicate that the system has entered the Start to flash and a single audible chime tone will (4) About ten seconds after the completion of Stepģ, the SKIS indicator in the instrument cluster will The second valid Sentry Key mustīe inserted in the lock cylinder within fifteen seconds Valid Sentry Key and turn the ignition switch back to The ignition switch lock cylinder with the second Than fifteen seconds, cycle the ignition switch back to Position for longer than three seconds, but no more (3) After the ignition switch has been in the On Ignition switch and turn the ignition switch to the (2) Insert one of the two valid Sentry Keys into the Cut theīlank key(s) to match the ignition switch lock cylinder Programmed as valid keys for the vehicle. (1) Obtain the blank Sentry Key(s) that are to be The Customer Learn programming method procedures To program new or additional valid keys to the SKIM. country codeĭesignator, the Secured Access Method must be used If two valid Sentry Keys are not available, Method also requires access to at least two valid Sentry The Customer Learn feature is only available onĭomestic vehicles, or those vehicles which have a Ill see if i can paste it here, (found it in 10 seconds) Tricky huh? and gets worse in time, the 2010 you cant do at all. The operators guide on all jeeps cover this.įirst off most newer cars, you need 2 keys to make a 3rd.Īnd new key must be new, as used ones will not program.
#SENTRY SAFE LOST COMBINATION S0207 PASSWORD#
0 kommentar(er)
